AVIV123
04-12-2009, 12:56:46
יש את המסוק BLADE MSR שהוא 4 ערוצים .
http://www.youtube.com/watch?v=sqlpf_wS428
ראיתי שבשימוש של DX7 יש חברים מחול שבוחרים מצב של מסוק.
האם למסוק 4 ערוצים לא עדיף לבחור מצב טיסן??
האם האגדרות יעזרו להטסת המסוק?
האגדרות שהומלצו
There really isn't much to the setup of this thing. With it being fixed pitch there is no advanced programming throttle and pitch curves or anything like that. All you can really do is setup up dual rates and expo.
But since you asked, on the dx7 I run:
heli mode 90 degree one servo
aileron rate 0, 100% with 30 expo
aileron rate 1, 50% with 30 expo
elevator rate 0, 100%, with 30 expo
elevator rate 1, 50% with 30 expo
rudder rate 0, 100% with (-)30 expo
rudder rate 1, 85% with (-)30 expo
I didn't find any need to adjust end points as all of my servos were travelling through the full range of motion staright from the box.
Running on the outer swash links.
This is how I am set up but I really don't switch rates on the msr, they just stay on high all of the time when I'm flying. Your ch5 switch can also be used to switch between a high low rate setting that affects all controls from one switch. I set the ch.5 low rate along with the individual low rates for my son when he is flying it in the house
http://www.youtube.com/watch?v=sqlpf_wS428
ראיתי שבשימוש של DX7 יש חברים מחול שבוחרים מצב של מסוק.
האם למסוק 4 ערוצים לא עדיף לבחור מצב טיסן??
האם האגדרות יעזרו להטסת המסוק?
האגדרות שהומלצו
There really isn't much to the setup of this thing. With it being fixed pitch there is no advanced programming throttle and pitch curves or anything like that. All you can really do is setup up dual rates and expo.
But since you asked, on the dx7 I run:
heli mode 90 degree one servo
aileron rate 0, 100% with 30 expo
aileron rate 1, 50% with 30 expo
elevator rate 0, 100%, with 30 expo
elevator rate 1, 50% with 30 expo
rudder rate 0, 100% with (-)30 expo
rudder rate 1, 85% with (-)30 expo
I didn't find any need to adjust end points as all of my servos were travelling through the full range of motion staright from the box.
Running on the outer swash links.
This is how I am set up but I really don't switch rates on the msr, they just stay on high all of the time when I'm flying. Your ch5 switch can also be used to switch between a high low rate setting that affects all controls from one switch. I set the ch.5 low rate along with the individual low rates for my son when he is flying it in the house