PDA

צפייה בגרסה מלאה : היא הגיעה : ARPRO 700 Deep-Vee



sharonx
26-08-2010, 18:07:43
היא הגיעה בשלום ארצה , ה ARPRO 700 Deep Vee (http://www.hobbycity.com/hobbycity/store/uh_viewItem.asp?idProduct=13772).

גימור מ-ד-ה-י-ם. פשוט מושלם "FLAWLESS".
טעימה לבינתיים, בהמשך יהיו סיקור וסרטונים מהשטח....

http://www.efly.co.il/forums/attachment.php?attachmentid=30767&stc=1&d=1282842256

http://www.efly.co.il/forums/attachment.php?attachmentid=30768&stc=1&d=1282842256

http://www.efly.co.il/forums/attachment.php?attachmentid=30769&stc=1&d=1282842256

sharonx
26-08-2010, 18:14:26
הסיני גאון באריזה - תראו מה הוא עשה - הפך את הקופסה.

http://www.efly.co.il/forums/attachment.php?attachmentid=30774&stc=1&d=1282842856

RoVal
26-08-2010, 18:50:41
מדהים, תתחדש ותהנה.
איפה אתה משיט? יש מקום באזור ראשון או שאתה נוסע יותר לאזורים שאחרים מכאן משיטים?

;)

noamg
26-08-2010, 20:33:50
גם אני קיבלתי פתק מהדואר לקחת אותה

Himel
26-08-2010, 20:59:45
רובל אם אתה מחפש איפה להשיט בראשון, אז ליד הסופרלנד יש שם את האגם, אנחנו מתחילים להשיט שם.

yoni_k10@walla.co.il
26-08-2010, 22:40:22
תתחדש שרון. מדהימה באמת

guyst
26-08-2010, 22:50:30
תתחדש איש!
אני רואה שיש לה כבר מדף משלה....:)
נכנסת חזק לסירות, אה...?

היא הכי יפה בצי שלך...

Tornadon
26-08-2010, 23:16:29
תתחדש איש!
אני רואה שיש לה כבר מדף משלה....:)
נכנסת חזק לסירות, אה...?

היא הכי יפה בצי שלך...

אכן הסירה יפה תתחדש
אני רעיתי את המדף בגירסאות הקודמות שלו...

יוני - היה נעים להכיר. נקרא לך כשנלך להשיט.

בינתיים, לאחר שמכרתי את הטירקס 500 המדף התפנה למהירות הקטנות שלי :

http://www.efly.co.il/forums/attachment.php?attachmentid=29791&stc=1&d=1281299495

http://www.efly.co.il/forums/attachment.php?attachmentid=29792&stc=1&d=1281299495

ilan_l
27-08-2010, 00:24:40
תתחדש , תן חוות דעת על הביצועים .

Himel
28-08-2010, 17:53:57
סירה מדהימה למרות היותה איטית טיפה [יחסית], יציבה מאד, מרשימה נראית מעולה על המים , ורואים שקירור המיים עובד שעות נוספות, הכל חזר קפוא.
+1

sharonx
29-08-2010, 01:37:09
הזמנתי היום :
פרופ אוקוטרה X440/3
http://www.offshoreelectrics.com/proddetail.php?prod=oct-x440/3
בקר 100 אמפר
http://www.lowpricerc.com/product_info.php?products_id=1016
סוללה 4 תאים
http://cgi.ebay.com/30c-14-8v-2800mAh-LiPo-14-8-Volt-4S-RC-AKKU-Battery-WF-/160472431690?pt=Radio_Control_Parts_Accessories&hash=item255ce6fc4a#ht_1829wt_917

אני אסב את הבקר לקירור מים עם פלטה.
1. מאיפה מזמינים פלטות קירור מים ? ב OFFSHOREELECTRICS הם לא במלאי.
2. אם אני צורך כ 70A במקס' אני יכול להשתמש בבקר 100A ללא קירור מים ?

Tornadon
29-08-2010, 02:56:06
הזמנתי היום :
פרופ אוקוטרה X440/3
http://www.offshoreelectrics.com/proddetail.php?prod=oct-x440/3
בקר 100 אמפר
http://www.lowpricerc.com/product_info.php?products_id=1016
סוללה 4 תאים
http://cgi.ebay.com/30c-14-8v-2800mAh-LiPo-14-8-Volt-4S-RC-AKKU-Battery-WF-/160472431690?pt=Radio_Control_Parts_Accessories&hash=item255ce6fc4a#ht_1829wt_917

אני אסב את הבקר לקירור מים עם פלטה.
1. מאיפה מזמינים פלטות קירור מים ? ב OFFSHOREELECTRICS הם לא במלאי.
2. אם אני צורך כ 70A במקס' אני יכול להשתמש בבקר 100A ללא קירור מים ?

http://www.r2hobbies.com/eng/proddetail.php?prod=rcps81933_30
http://www.r2hobbies.com/eng/proddetail.php?prod=rcps81933_80

בקר 100 אמפר ללא קירור יתחמם באותה מידה לא מומלץ

sharonx
29-08-2010, 07:35:09
תודה הזמנתי. יש דבק מיוחד לאיטום בקרים או שסיליקון רגיל מספיק ?

Tornadon
29-08-2010, 09:27:48
אני השתמשתי בסיליקון RTV עמיד בחום משתמשים בזה לרכב עתם ראוש מנוע
בנתיים מחזיק הכול
אבל נירא לי שגם תוכל להשתמש בסיליקון רגיל מטמבור

sharonx
29-08-2010, 19:26:04
תשובות שענה לי בחור מומחה ב RCG, והשאלות שלי. אפשר ללמוד מזה הרבה ועדיף להתגלח על ניסיון של אחרים. 4S - כנראה צריך מנוע חדש.

Hi Sharon,

1) You're welcome.

2) Yes, most metal props need to be sharpened and balanced; a dull prop will generate a lot of spray, but not much speed, a non-balanced prop can cause severe vibrations that will rip the drive line out of the boat.

3) I'm running my Arpro on a 100A ESC, my son runs his on a 45A ESC, both are watercooled and get luke warm.

I've tried the motor on 4S with a 40 mm two-bladed prop and fried it, so in my experience, no the stock ourtunner won't take 4S.
This is the motor; as you can see, the 1520KV is specified to run on 2-3S Lipo, I wished I had found this info prior to frying one of my motors:
http://bidproduct.com/part/Product_v...0MOTOR_52.html

4) the motor draws about 60A max on 3S, with the watercooled 45A ESC that's no problem, but my 100A Mystery also gets warm, and it's watercooled too.

In my experience a 100A ESC has very little headroom to run the stock outrunner without watercooling (or a mini fan blowing on the heatsink, but(!) when running a fan when the ambient temperature is high, which can be the case in Israel, if I'm not mistaken, the cooling will be less efficient and most likely not enough to keep the ESC from overheating).

Having said this; our boats have to run for six minutes and run on a 3300mAh 3s Lipo, this is more than enough to run the six minute heat. a full charge gives us close to 10 minutes of runtime, which tends to heat up both motor and ESC, without an efficient watercooling I wouldn't try it.

I make my own watercoolers, so I can adapt them to fit the various sizes ESC I use.
Basically it's a 6 mm piece of aluminum, drilled accoding to the picture.
Two tubes glued in with loctite and the cross section blocked with a M4 grubscrew:


ETTI also has cooling plates, check if they fit onto your ESC, prior to ordering.

Regards, Jan.

I'm from the Netherlands.


Originally Posted by sharonx :


1. Thanks for helping me so far.
2. I ordered for the arpro :
- octura prop (x440/3) - unbalanced. Must I balance ?
- ESC http://www.lowpricerc.com/product_in...oducts_id=1016
- LIPO 4S http://cgi.ebay.com/30c-14-8v-2800mA...#ht_1829wt_917

3. Will the motor take 4S ? How much current should I expect for 4S ?

4. If max carrent is around 70A - can I use 100A ESC without water cooling ?
5. Last question - where can I order water cooling plates ? offshoreelectronics has them but they are out of stock.

P.S
Where are you from ?

Thanks a lot,
Sharon

noamg
29-08-2010, 20:22:57
שרון,
נראה לי שאם המטרה שלנו הינה תחרויות אזי נישאר עם הסטאפ המקורי ורק נחליף פרופ.
אכן יש צורך לאזן את הפרופים, אחרת הביצועים יורדים, המנוע ניזוק, הציר יכול לזוז וגם הסירה נחלשת - כנראה זה מאד מהותי.
אני אקנה מאזן פרופים מקצועי ונאזן לכולם את הפרופים.

sharonx
21-09-2010, 00:55:52
בואו נאסוף כסף, נקנה את ה ARPRO אמיתית ונחשמל אותה :D

http://www.efly.co.il/forums/attachment.php?attachmentid=32175&stc=1&d=1285026732

http://www.efly.co.il/forums/attachment.php?attachmentid=32176&stc=1&d=1285026732

Tornadon
21-09-2010, 09:47:51
אני מביא טלת פאזי
:D

sharonx
22-09-2010, 22:08:33
סרטון של ה ARPRO האמיתית - איזו בהמה !: :eek:

http://www.youtube.com/watch?v=FNbZKlY9Nac&feature=player_embedded

sharonx
23-09-2010, 16:26:33
ARPRO עם FLOOD CHAMBER

http://www.youtube.com/watch?v=e9wYBeG-1U4&feature=watch_response
שרשור הבנייה
http://www.rcgroups.com/forums/showthread.php?t=1065830

sharonx
01-01-2012, 22:47:41
http://www.youtube.com/watch?v=zSAJTmQOH4c

איזו נוסטלגיה

noamg
02-01-2012, 06:37:24
שרון, אנחנו משיטים כמעט כל יום שישי רק מנועיות. אתה מוזמן.

stase4ky
22-10-2014, 09:13:28
שלום חברה האיברית שלי לא כול קח טובה ישמח שאני ידבר בטלפון 0546571982 קוראים לי סטאס אני חדש בתחום ורציתי לשאול קמה דברים תודה ואשמח לעוד שיעזרו לי. תחום שלי סירות מירוץ