נכתב במקור על ידי
Boogle
יש לך טעות בסדר העבודה בהפעלה רגילה..
בקורונה V2 אתה קודם כל מדליק את המקלט,
ואז מדליק את המשדר , המתנה של עד חצי דקה לנעילה. אם לא ננעל פשוט צריך לכבות ולהדליק שוב לפי הסדר של משדר אח"כ מקלט.
הנה מהמנואל :
Receiver and Transmit ter Setup Instruct ions
By following these steps you wil l ensure your transmit ter and receiver are proper ly setup and ready to fly.
1. Turn the transmit ter on and adjust your transmit ter to PPM mode and then turn the transmit ter of f.
2. Press and hold the programming but ton on the transmit t ing module, turn the transmit ter on, then you can release the
but ton.(At tent ion: Not keep hold the but ton down over 3 seconds,or its ID will change randomly) The LED on Module wi ll
f lash between red and green indicat ing the transmit ter is ready to bind with the receiver .
3. Press and hold the but ton on the receiver and power the receiver on. The LED on the receiver will f lash two t imes ,
indicat ing the receiver have recognized the transmit ter . Turn of f the transmit ter and receiver.
4.Power on the receiver(s) without pressing any but ton, then power up the transmit ter also wi thout pressing but ton, the
LED on the transmit ter l ight yellow. The RF-link wil l normally connect in 15~20 seconds between transmit ter and the
receiver (s) . I f l inked the LED on the receiver (s) will light red without any f lash indicat ing the receiver(s) is operat ing
proper ly. I f the LED f lashes somet ime or does not light at all. Repeat this step unt il link is connected proper ly.
Af ter set up receiver and transmit ter ,user only take the 4th step in normal flying.
עזרה עם מודול CORONA 2.4 DSSS
ציטוט ההודעה בתגובה
